Sima STP-3000 Instrukcja Właściciela

STP-3000 12V DC POWER INVERTER OWNER'S MANUAL Sima Products Corporation 140 Pennsylvania Ave. Bldg. #5 Oakmont, PA 15239 800-345-7462 www

8.2 Troubleshooting Guide Problem and symptoms Possible Cause Solution Low output voltage (96 to 104 V AC) Using an average reading voltmeter. Use t

Appendix B – Connection to Multiple Batteries Identical batteries can be connected “+＂to“+＂and“–＂to“–＂ in a parallel for larger capacities while mai

10. Limited Warranty Sima Products Corporation (“Company”) warrants that if the accompanying product proves to be defective to the original purchase

NotesPage 13 of 14

Sima STP-3000 Inverter Owner’s Manual © 2005 Sima Products Corp., Limited. All rig

STP-3000 Owner’s Manual Table of Contents 1. Introduction ...

SIMA STP-3000 12V DC Owner's Manual 1. Introduction Your new Sima STP-3000 inverter is the most advanced DC to AC inverter available today fro

3. Physical Layout of the Sima STP-3000 Power flows logically from the rear terminals of the Sima STP-3000 unit forward to the front panel of the AC

4. Permanent Installation 4.1 Where to Install The following environmental requirements are essential for installing the inverter: a) Dry - Do not a

5. Cable Hook-up CAUTION! Loose connectors result in excessive voltage drop and may cause overheated wires and melted insulation. CAUTION! Revers

5.1 Battery Cables ( if cable installation kit is not included) Safe operation of the Sima STP-3000 requires proper wires. Low resistance wiring fro

B. Ground Wiring The Sima STP-3000 has a lug on the rear panel to connect the chassis of the inverter and its AC output ground to the AC distribution

G. ALARM Indicator –Audible alarms will sound off if any of the following conditions occur: a) OVERTEMP condition b) Low Battery Voltage : <10.7V